Trimod MCS

• Do manual bypass operations involve switching off the load?
• How is the back-feed realised?
• How do you set up additional batteries?
• Do batteries release flammable gases?
• How do you set the output voltage?
• What are the ideal environmental installation conditions?
• How is the SNMP adapter configured?
• Is it compulsory to install the E.P.O. circuit?
• Is the E.P.O. circuit set in NC/ NO?
• Is it necessary to install UPSs in ventilated rooms?
• Are the products parallel?
• Does the legislation provide for the use of back-feed protection?
• How do you set the output frequency?
• Where is the accessory kit located?
• What are the correct steps to follow for proper commissioning?
• What is the correct sequence for the first ignition?
• Why does the UPS not switch on if I only close the mains fuses?
• Why does the UPS display the "start up error"?
• When can I close the battery fuses?
• Do the battery settings have to be changed?
• What configurations does the UPS with dual inputs require?
• Why does the display flash when the generator is switched on?
• How do you set the range of the PLL?
• How do you set the output voltage?
• What are the input-output configurations?
• Do batteries have to be configured?
• Where can I find the menu to configure the inverter?
• What is the correct differential protection for UPSs?
• Where should the ec15 connector be plugged in?
• How are the jumpers configured in the terminal box?